![]() ![]() A short or open circuit on the A board may also be responsible for their absence.įive, Seven, or Eight Time Blinking: 5 Blinks, 7 Blinks, 8 Blinks Error The MPU IC1100 monitors for their presence when the unit is connected to AC Power. The DTV9V and SUB_5V sources are produced on the AP board. The AP board is responsible for four or six blinks of the power LED. An over-current condition may be due to a short circuit located in the AP board, Aboard, or the LCD panel.įour or Six-Time Blinking: 4 Blinks, 6 Blinks Error An over-voltage condition is definitely a defect of the AP board. Therefore the use of an ohmmeter and a peak-hold voltmeter is required to determine the cause of the shutdown. Three blinks of the power LED indicates an over-current or over-voltage condition in one of the DC supplies of the AP board. The inverter board is not to be repaired in One blink of the power LED indicates a problem in the inverter circuit located on the LCD panel. ![]() Communication Error Between T-Con Processor and Main Board Microprocessor.Balancing Error (Back-light Dimming) (LED).Check VDR and Fuse is the Power SupplyĬontinuous Blinking: Problem in Jungle IC. Following blinking codes behaviors may be different according to different models: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |